Industrial Data Systems IDS DT200 - Manual (Page 7)

5
3.1.0 SET CLOCK
Activate the CONFIGURE menu and press the ENTER key when the DT210
displays 'SET CLOCK'.
The DT210 prompts: "TIME HHMM*"
where HH = hours, MM = minutes, and * = P for PM, A for AM or space for 24hr time. Enter
the hours (2 DIGITS!), the minutes and then "A", "P", or space. Press the ENTER key to
complete the time entry.
The DT210 prompts: "DATE MMDDYY"
where MM = months, DD = day, and YY = year. Enter the month (2 DIGITS!), the day, and the
year. Press the ENTER key to complete the date entry.
The DT210 then displays entered time and date. Press the ENTER key to set the time and date
into the clock.
The DT210 prompts: "ADJUST S/D- XXXX"
where XXXX = the number of seconds per day to adjust the clock. Enter a 0 when installing the
DT210. If the clock is slow enter the number of seconds/day that the clock is slow. If the clock
is fast enter the NEGATIVE number of seconds/day.
NOTE: The numeric display will show the number of days since the clock was last set.