Industrial Data Systems IDS DT200 - Manual (Page 34)

32
6.4 25 PIN 'D' CONNECTOR WIRING LIST
PIN # SIGNAL NAME
1 CHASSIS GND
2 #1 RS232 TXD
3 #1 RS232 RXD
4 #1 RS232 RTS
5 #1 RS232 CTS
6 +5 R
7 GND
8 #1 CUR LOOP IN +
9 #2 RS232 RXD
10 #2 RS232 TXD
11 #2 RS485-
12 #2 RS485 +
13 GND
14
15 #1 PULSE INPUT
16 TTL INPUT
17 TTL INPUT
18 #2 CUR LOOP IN +
(#2 RS422 IN +)
19 #2 CUR LOOP IN -
20 +5 R
21 #2 RS422 IN -
22 #1 CUR LOOP IN -
23 +5 V
24 #2 CUR LOOP OUT
25 #1 TTL RTS
NOTES: When using RS232 INPUT, set DT210 jumper W2 on and W3 off. When using
current loop set jumper W3 on and W2 off.
When not using handshake jumper CTS to RTS (pin 5 to 4).
When using the Star Micronics DP8340, use pin 20 on the
DP8340 for "CTS" signal.