Panasonic NV-SJ230A - Manual (Page 2)

Warning and ¡mportaní
Information
As this equipment gets hot during use, operate it
in a well ventilated place; do not install this
equipment in a confined space such as a book
case or similar unit.
WARNING:
To reduce the risk of fire electric shock or
product damage, do not expose this equipment
to rain, moisture, dripping or splashing and
ensure that no objects filled with liquids, such as
vases, shall be placed on the equipment.
Important
Your attention is drawn to the fact that the recording of
pre-recorded tapes or discs or other published or broadcast
material may infringe copyright laws.
For your safety
Do not remove outer cover.
Touching internal parts of the VCR is dangerous, and may
seriously damage it.
To prevent electric shock, do not remove cover. There are no
user serviceable parts inside. Refer all servicing to qualified
service personnel.
Inserting Remote Control Batteries
insert the batteries with the polarity (© and ©) correctly
aligned.
Notes:
The service life of the batteries is approximately 1 year.
However, it varies considerably depending on the frequency
of use.
- When they are exhausted, replace them with two AA, UIVI3,
or R6 size batteries.
- When the batteries are exhausted, remove them
immediately and dispose of them correctly.
- Make sure that the batteries are inserted with the polarity
(© and 0) correctly aligned.
- Do not mix old battery with new battery.
- Do not mix different battery types, i.e. Alkaline and
Manganese.
- Do not use rechargeable (Ni-Cd) batteries.
- Do not heat or short-circuit the batteries.
- When you do not use the remote control tor a long time,
take out the batteries and store them in a cool, dry place.
Cautions before you operate this VCR
Avoid;
- Humidity and dust.
- Covering the ventilation holes with soft materials such as
cloth or paper.
- Extreme heat such as direct sunlight.
- Magnets or electromagnetic objects.
- Touching internal parts of the VCR.
- Water or some other liquid.
- Lightning. (Disconnect the aerial plug from the VCR during
lightning storms.)
- Anything heavy on the VCR.
- Connecting or handling the equipment with wet hands.
- Using a ceil phone near the VCR because doing so may
cause noise to adversely affect the picture and sound.
Do:
- Wipe the VCR with a dean and dry cloth.
- Install the VCR in a horizontal position.
- Keep the VCR, TV and other equipment switched off until
you have finished al! connections.
Condensation may form in the following cases:
- The VCR is brought from cold surroundings into a
weil-heated room.
- The VCR is suddenly brought from cool surroundings, such
as an air-conditioned room or car, to a place which is hot
and humid.
Note:
- In any of the above-mentioned conditions, do not operate
the VCR for at least 1 hour.
This VCR is not equipped with a dew sensor.
Press the VCR POWER button 0 to switch the VCR from on
the standby mode or vice versa, in the standby mode, the
VCR is still connected to the mains.