Acura 2000 TL - Owner's Manual - Manual (Page 207)

Engine Oil
WASHER DRAIN BOLT
2. Open the hood and remove the
engine oil fill cap. Remove the oil
drain bolt and washer from the
bottom of the engine. Drain the oil
into an appropriate container.
OIL FILTER
3. Remove the oil filter and let the
remaining oil drain. A special
wrench (available from your Acura
dealer) is required to remove the
filter.
4. Install a new oil filter according to
instructions that come with it.
5. Put a new washer on the drain bolt,
then reinstall the drain bolt.
Tighten it to:
29 lbf-ft (39N-m, 4.0 kgf-m)
Maintenance
Main Menu Table of Contents