Acura 2000 TL - Owner's Manual - Manual (Page 240)

Lights
3. Remove the bulb by turning it
approximately one-quarter turn
counterclockwise.
4. Insert the new bulb into the hole
and turn it one-quarter turn clock-
wise to lock it in place.
5. Push the electrical connector back
onto the bulb. Make sure it is on
all the way.
6. Turn on the headlights to test the
new bulb.
7. Reinstall the radiator reserve tank.
Replacing Front Turn Signal and
Side Marker Light Bulbs
1. If you are changing the bulb on
the driver's side, start the engine,
turn the steering wheel all the way
to the right, and turn off the
engine. If you are changing the
bulb on the passenger's side, turn
the steering wheel to the left.
HOLDING CLIP
2. Use a flat-tipped screwdriver to
remove the holding clip from the
inner fender.
3. Pull the inner fender away from
the fender and bumper.
CONTINUED
Maintenance
Main Menu Table of Contents