Agasio A502W - Manual (Page 47)

More Security More Convenience
3.18.4 IO Pins for IO Alarm Linkage
Figure 10.3
O PINS: 1 Output 2 Output 3 Alarm input 4 Input (GND)
Input pins: The input pins can be used for 1-way external sensor input. For example, you may connect a
e
ut Armed (Figure 10.0),
ns can be enable IO linkage on alarm.
I/
Person Infrared Sensor (PIP) to it for motion detection. When external sensor triggered, IP CAMERA can b
programmed to send an email with picture or control the internal relay output.
If you link an external alarm device with Pin3 and Pin4, when select Alarm Inp
external alarm is enabled.
Output pins: The output pi
You can also use & to control IO output Switch ON/OFF (See Figure 4.4).
a
3.19 Send Mail on Alarm
Choose it, it will sent picture and mail inform to customer’s e-mail once alarmed. (Firstly you should finish the
hots by one email to your mailbox for each alarm triggered. Each alarm will
pload Image on Alarm
Alarm to set upload images to FTP once alarmed.
NOTE: All the pins work s switch only.
Mail Service Settings. Figure 9.1)
NOTE: It usually will send 6 snaps
last for 60 seconds.
U
Enable Upload Image on
Upload Interval: Set the upload interval (Seconds).
NOTE: The total alarm time is 60 seconds.
Figure 10.4
cheduler
ere you can set the camera alarm during the time you set. Choose Scheduler and set the date & time range.
e 8.3)
e when motion triggered.
S
H
(Figure 10.5) From Monday to Sunday, and every day divide into 24 hours, each hour divide into 4 quarters.
Left click the frame of the time range, it will turn to blue color, means the time you choose armed.
Click it again, it will turn back to grey, means delete the scheduler.
NOTE: Make sure the date & time settings are correct firstly.
(Figur
ATTENTION: If you don’t choose Scheduler, the camera will alarm anytim
47