Agasio A502W - Manual (Page 6)

More Security More Convenience
There are some stic bottom of IPCAM, such as MAC address sticker, QC sticker etc.
e the original
ESET BUTTON: Press and hold the RESET BUTTON for 15 Seconds, then the IPCAM will be reset back to
equirements
ystem configuration requirements :( Example for viewing four IPCAM)
ove
mory
Windows 2000/ XP/ Vista/ 7
ware Instruction
ollow the steps below to set up your camera hardware. Make sure to follow each step carefully to ensure that
to camera
nd router/switch
you will find the IP address from
5. W cable connected, the green led of the real panel will keep on,
dicator LED
kers at the
If your camera does not have these stickers, it may be a fake one, fake IPCAM could not us
firmware and obtain our good after sale service.
R
the factory default Parameter. (Please keep the power on when do RESET)
1.4 PC System R
S
CPU: 2.06GHZ or above
Memory: 256M or above
Network Card: 10M or ab
Display Card: 64M or above me
Recommendable Operating system:
1.5 Hard
F
the camera operates properly
1. Install the Wi-Fi antenna
2. Plug the power adaptor in
3. Plug the network cable into camera a
4. It takes approx 30 seconds to boot up the camera, then
“IP Camera Tool” (Figure: 2.1)
hen the power on and network
The yellow led will keep flash, and the Indicator led at the front of the camera will flash. (The in
can be controlled by software)
Figure1.4
6