ALTANA Byko-Drive Manual - Manual (Page 12)

10
English
Start Up
4. Start Up
Plug the external power supply into the connector
on the left side near the power switch. Plug the
other end into an appropriate electrical outlet as
described in Section 2.
Turn on the power switch. The power switch is
located on the left side of the instrument, near the
power cord.
The carriage will cycle to the start point and the
LED will turn green, the instrument is now ready to
operate.
The three states of the LED are as follows:
Green – Power on, waited for a command
Amber – Carriage is moving
Red
– An error has occurred