ALTANA Byko-Drive Manual - Manual (Page 9)

7
English
Preparations
2. Preparations
Unpack the unit being careful to check all packaging
for items. Some accessories may be found in a se-
parate box within the main box. Within the package
are the following standard items:
Quantity Description
1 byko-drive Applicator unit
1 Power Supply
1 Power Cord
1 Weight
1 Drip Pan
1 *Brass Barb Fitting
2 Spare O-Rings for Weight
*This item is only included with vacuum plate equipped models
Locate a suitable location free from obstructions and
clutter. The byko-drive should be at a convenient
height for the operator.
Plug the power supply into the DC input jack on the
left side, next to the power switch. A power cord
appropriate for your area’s power connector is sup-
plied to connect the power supply with AC power.
The system will operate on power from 100-240 V~
at 50-60 Hz.
If you have the model with the built in vacuum plate,
install the provided barb fitting and attach a vacuum
source. If the provided fitting is not appropriate for
your vacuum source, a customer supplied fitting
may be used that is compatible with the ¼ NPT
thread in the vacuum plate.
Place the drip pan in the provided indentation on the
right of the vacuum plate.
The weight is used to provide additional pressure on
an applicator or hold a wire-wound rod in the proper
position. If needed, place the weight on the pins of
the pusher bar.