ALTANA Byko-Drive Manual - Manual (Page 14)

12
English
Operation
To Set a New End Position
Follow the same procedure as above, except press
and release the Set End Position button to set the
end point. The LED will blink and the position is
stored in memory. This position will remain stored
even with the power off.
To Clear the Set Start or End Position
To clear the memorized position, hold down the
Set Start or Set End position button for 5 seconds.
When you release the button, the LED will blink and
the position will be reset to the default.
To Change Speeds
The byko-drive has two speeds, 1 inch/sec (25 mm/
sec) and 10 mm/sec. The unit is shipped set to the 1
inch/sec setting. Hold down both the Forward but-
ton and the Set End Position button for 5 seconds.
When you release the buttons the LED will blink
twice to indicate Speed 2 (10 mm/sec) has been
selected, and the carriage will return to the home
position. To change back to Speed 1 (1 inch/sec),
press the Forward and the Set End Position buttons
for 5 seconds. Release the buttons and the LED will
blink once and the carriage will return to the home
position.
To Make a Drawdown
Place a test chart or other substrate material on the
vacuum plate. Turn on the vacuum source. (For mo-
dels with the glass plate, simply place the substrate
on the glass, under the sample clamp)