Food processor parts and features, Food processor assembly – Cuisinart BFP-10 Series User Manual

Page 8

Advertising
background image

1

2

3

4

5

6

7

8

8

• When chopping fresh herbs, garlic, onion, zest, bread crumbs,

nuts, etc., make sure the blender jar and cutting assembly are
completely dry.

• If food tends to stick to the sides of the blender jar or food

processor work bowl during use, pulse in short bursts.

DON’T:

• Don’t store food or liquids in your blender jar.

• When using blender, don’t place cutting assembly and locking

ring onto motor base without the blender jar attached.

• Blender or food processor will not mash potatoes, knead dough,

or beat egg whites.

• Don’t remove blender jar or food processor bowl while unit is

ON. Keep the blender jar or food processor cover on while
blending.

• Don’t twist locking ring from blender jar when removing blender

jar from motor base. Simply lift blender jar from motor base.

• Don’t overprocess foods. Blender or food processor will achieve

most desired results in seconds, not minutes.

• Don’t overload blender or food processor. If the motor stalls, turn

OFF immediately, unplug the unit, and remove a portion of the
food; then continue.

• Don’t use any utensil inside the blender jar or food processor

bowl while the motor is ON.

• Don’t use any container or accessories not recommended by

Cuisinart. Doing so may result in injury.

• Don’t place hands inside the blender jar or food processor bowl

when blender is plugged in.

• Don’t add boiling liquids or frozen foods (except ice cubes or ½"

pieces of frozen fruit) to glass blender jar. Boiling liquids should
cool for 5 minutes before being placed in blender jar.

• The food processor accessory is not intended to crush ice. This

could damage the chopping blade and will damage work bowl.

FOOD PROCESSOR PARTS
AND FEATURES

1. Food pusher with oil dispenser

2. Work bowl cover with feed tube

3. Stainless steel chopping blade

4. Stainless steel reversible slicing/

shredding disc

5. Adapter stem

6. Clear work bowl

7. Gearbox collar

8.

Motor base
Used for both the blender jar and
the food processor bowl

FOOD PROCESSOR
ASSEMBLY

Please note that the bowl and collar will fit
on the base in eight different positions. The
handle can be in front or on either side and
the feed tube in front, back, or on either side.
Directions for use reference a certain
position for instructional purposes only.

1. Hold gearbox collar in one hand and

work bowl handle in the other. Twist bowl
clockwise onto collar.

2. Place collar with bowl onto motor base

with handle facing front.

Now follow directions below for either:

a) chopping, puréeing and mixing or

b) slicing and shredding

a) CHOPPING, PURÉEING & MIXING

1. Place chopping blade over shaft in work bowl. Chopping blade

should slide easily to the bottom of the bowl. Lower blade will
almost touch bottom of bowl.

Advertising
This manual is related to the following products: