Avlink PG-H1 - Manual (Page 10)

9
HDCP: PG-H1 had enabled HDCP function. Enable this
function to accept the high video resolution. (You can
enable this function by press MENU/Func/Setup to HDCP
item as switching to “0”.)
3.2 Power and Battery
The device is suited to the DC 12V 1.25A power adapter
and 4 inside Re-chargeable batteries. The signals of
PG-H1’s battery on the lower right are described as below:
„
“ ”: The power of battery is charging.
„
“ ”: The power of battery is in full charging.
„
“ ”: The battery is fault.
)
1. When the device stands by for about 39 minutes, it
will sound two short “beep”. After the two short
“beep” sounds about 1 minute, the device will sound a
long “beep” and shout down automatically.
2. When the battery is lower as “ ”, a warming sound
“beep” will be heard and the device will shout down
immediately.
3.3 MENU Configurations
) T he figures in this chapter are for P01 FLAT 640x480
@60 mode reference
After you power on the PG-H1, please press the MENU
indicated key. The MENU configuration screen will be
showed as below:
3.3.1 Tim configuration
Press the Tim indicated key, the Tim configuration screen
will be showed as below: