Bike2Power SpinPower - Manual (Page 10)

ENGLISH
10 | P a g e
Copyright © 2012 Bike2Power. All rights reserved
Step 2. Secure the holder in desired position
a. Use adjustment wheel (C9) to secure the holder in a desire position.
Rotating adjustment wheel can loosen or secure the angle of the holder’s
position.
To Remove a Phone Holder
a. Slide the holder up and out
Operating SpinPower Kits
Connecting mobile devices
Step 1. Place your mobile device into the phone holder
Step 2. Connect mobile device to charger
a. Use USB charging cable provided with your mobile device
b. Plug the USB end of your charging cable into the charger’s USB port (C5)
Charging mobile devices
Step 1. Connect the mobile device to the charger
Step 2. Begin pedaling faster than 4 miles per hour which typically a walking speed
Step 3. If charging does not begin immediately after you start pedaling, do one of the
following
a. Increase speed
b. Stop the bicycle and adjust the dynamo’s position to the correct position
c. Stop the bicycle and check all connections including your USB cable
d. Stop the bicycle and detach USB charging cable from your mobile device
for a few seconds
Note: While charging your mobile device, the dynamo output may not be enough
to charge your mobile device if you use a Bluetooth® headset with it.
Taking Care of Your Device
(!) Handle your SpinPower Kits’ devices and accessories with care.
Keep the devices dry. Any type of moisture can corrode the electronic circuits. That includes
humidity, precipitation, and all types of liquids. If the devices become wet, allow them to dry
out completely.
Avoid using or storing the devices in the dirty and dusty areas. Moving parts and electronic
components of the device can become damaged.
Do not attempt to open the devices. Do not bend, drop, or crush the devices. Avoid dropping,
knocking, or shaking the devices. Rough handling may result in damage to the mechanical
parts of the device.
Use only soft, clean, and dry cloth to clean the surfaces of the devices.