Bike2Power SpinPower - Manual (Page 8)

ENGLISH
8 | P a g e
Copyright © 2012 Bike2Power. All rights reserved
To Disengage the Dynamo – the dynamo may be disengaged without removing it while
not in use
a. Press the release lever down
b. The dynamo will snap away from the rim
c. Reengage by pressing the release lever and pushing the dynamo toward
the tire until it clicks in place
Mounting Holder Bracket with Charger
(!) Use only the supplied holder bracket with charger
Step 1. Attach charger to a handle bar
a. Loosen the security screw (C3) to separate the top and bottom of the
mounting bracket (C2).
b. Wrap the mounting bracket around the handle bar. The charger (C4)
should be on the bottom of the handle bar. The phone holder bracket (C1)
should be at the top. Remove the lining sheets as necessary to
accommodate the diameter of the handlebar.
c. Reconnect the top and bottom of the bracket with the security screw. Do
not over-tighten.
To Remove the Holder Bracket
a. Loosen the security screw, unwrap and remove the holder bracket from
handle bar
Connecting Dynamo and Charger
Step 1. Connect the electrical wire (C6)
(!) The electrical wire is the red-color wire
a. Insert the oval connector at the end of the red electrical wire (C6) into
electrical wire port (B3)
b. Press firmly until connector is firmly lodged inside the port.