Bike2Power SpinPower - Manual (Page 3)

ENGLISH
3 | P a g e
Copyright © 2012 Bike2Power. All rights reserved
Copyright
Copyright 2012© by Bike2Power. All rights reserved.
All brands and product names mentioned herein are the property of their respective owners.
Introduction
SpinPower Bicycle-mounted Phone Charger Kits allow charging a mobile device that is able to
charge via USB while riding a bicycle. The kits are designed to be used with the regular
(utility) bicycles.
SpinPower S1 Kit is compatible with the majority of the Smart® phones makes and models
including androids. SpinPower I3 Kit is compatible with iPhone® 3G/3GS and some older
iPhone® models. SpinPower I4 is compatible with iPhone® 4G/4S.
Charging with SpinPower Kits begins at as low as walking speeds. Install the entire kit;
connect your mobile device to the 2.0 USB charger port using your mobile device USB charging
cable, and begin pedaling.
Read this guide carefully before installing and using SpinPower Kits. Review the user guide for
your bicycle and your mobile device before installing the kit and connecting the mobile device.
Safety Instructions
(!) CAUTION
Obey your local laws. Always keep your hands free to operate the bicycle while cycling. Road
safety must be your first concern while cycling. Do not attempt to make or receive calls, or
operate your mobile device while cycling. Do not attempt to connect your mobile device to the
charger while cycling. Always stop to initiate, modify, or terminate any function on your mobile
device or to connect your mobile device to the charger.
Only operate the kit if it is safe under the cycling conditions. Do not attempt to remove or
adjust any portion of your kit while cycling. Always stop and loosen the bolts or screws to
adjust any portion of the kit. Make sure all parts of the kit are secure before resuming your
ride.
Allowing connector wire to hang loose is dangerous. Always secure the excess loose connector
wire away from the moving, steering, or braking parts of the bicycle.
When installing the kit, make sure that it does not interfere with or hinder any of the bicycle
moving, braking, or steering parts. Make sure that the kit is installed where you cannot come
in contact with it in the event of an accident or collision. Always make sure all parts of the kit
are securely installed before and after the ride. If you are not sure how to install any portion of
the kit, consult or hire a professional installer.
Dynamo hub may become warm during operation. Do not touch the dynamo for a few minutes
after completing your ride.