Bike2Power SpinPower - Manual (Page 9)

ENGLISH
9 | P a g e
Copyright © 2012 Bike2Power. All rights reserved
Step 2. Connect the grounding wire (C7)
(!) The grounding wire is the black-color wire
a. Slightly loosen the middle bracket bolt (A3)
b. Slide the metal end of the black grounding wire (C7) between the bolt’s
head and the exterior bracket (A1)
c. Tighten the bolt to achieve firm hold.
d. Avoid over-tightening.
Step 3. Connector wire (C8) management
(!) Because the bicycle sizes are different, you will likely have some excess connector
wire (C8) left. You may follow the recommended steps below to secure the excess
connector wire. Allowing excess wire to hang loosely is dangerous. Always make sure
the excess wire is secured away from the steering, operating, and breaking parts of the
bicycle before operating the bicycle.
Securing excess wire with electrical tape
Step 1. Gather excess wire and bunch it together. Leave just enough slack allow
the electrical wire and grounding wire to stay in place.
Step 2. Secure the bunched up portion of the connector wire with electrical tape
by wrapping electrical tape around the gathered up wire.
Step 3. Secure connector wire along the bicycle stem by attaching the wire to the
stem with electrical tape
Securing excess wire with zip ties
Follow Step 1 and Step 2 above.
Step 3.
Secure connector wire along the bicycle stem by attaching the wire to the
stem with zip ties.
Step 4. Trim down the zip ties as desired.
Attaching a Phone Holder
(!) Use only the holder provided
Step 1. Install a phone holder (D1, D3, or D5)
a. Align the grove on the back of the phone holder (D1, D3, or D5) and the
phone holder installation slots (C10) and insert the groves into slots.
b. Press in and down firmly until the holder snaps in place. Listen for the
clicking sound which indicates that the holder is firmly in place.