Bike2Power SpinPower - Manual (Page 7)

ENGLISH
7 | P a g e
Copyright © 2012 Bike2Power. All rights reserved
Mounting Dynamo
(!) Use only the supplied dynamo.
The dynamo may be installed in the two positions shown below. Note that the dynamo
release lever must be facing the spokes. Position “2” is recommended whenever a
bicycle has the front breaks. The installation steps below can be applied to the
installation in the either position, “1” or “2”.
Position “1” – L fork facing front Position “2” – R fork facing rear
Step 1. Attach dynamo (B) to the exterior mounting bracket (A1)
a. Attach dynamo to the exterior mounting bracket (A1) using the provided
adjustment bolt (A4) with nut and washer.
b. Attach through dynamo mounting hole (B2).
c. Tighten the bolt to achieve firm hold. Do not over-tighten.
Step 2. Attach the brackets (A1 and A2) to the front bicycle fork
a. Attach the mounting brackets (A1 and A2) to the bicycle fork. Interior
bracket should be positioned between the fork and the wheel.
b. Use the provided bracket bolts and washers (A3). These bolts are provided
in two different lengths sizes. Select the length that best accommodates
the diameter of your bicycle’s fork.
c. Tighten the bolts for the firm hold. Do not over-tighten.
Step 3. Adjust dynamo position
a. Dynamo’s friction roller (B1) should be firmly touching the middle of the
tire at a right angle
b. Adjust the friction head’s position to the correct position by slightly
loosening the bolts and adjusting the roller’s height, angle, and distance
until the correct position is reached.
Step 4. Tighten the bolts
a. Once the correct position is reached, tighten all bolts to achieve the firm
grip.
b. Avoid over-tightening.
To Remove the Dynamo
a. Loosen the bolts and remove the brackets from the fork.