Chameleon Labs 7602 MKII X-Mod - Manual (Page 11)

4- Turn the Output control clockwise until you can see
level on the input of your recorder. Increase until the
desired level is achieved. (Vintage Hint: Adjusting the
Microphone / Line sensitivity control along with the
Output control can provide a variety a different sounds
by overdriving the amplifier circuits while lowering the
final output level in order to not overdrive the recorder.)
5- If you wish to connect the equalizer section to the
line output of your board or D.A.W., simply connect to
the female, Line Input XLR on the rear panel.
6- When an electronic instrument such as an electric
guitar is used, it may be plugged directly into the ¼” DI
plug located on the front panel. Toggle the DI switch to
select this input device.
7- If phase reversal is needed, toggle the phase switch
(a zero symbol with a diagonal line through it).
8- To insert the equalization section into the circuit,
toggle the EQ switch. Each section can be set to OFF
with the frequency selector knob. As you add or
subtract gain within the equalizer, be sure to adjust your
overall gain with the output control. When the output
control can no longer make the adjustments that you
need, you may switch to a higher or lower gain setting
on the Microphone / Line sensitivity control.
11