Chameleon Labs 7602 MKII X-Mod User Manual
Page 8
Power Supply Connection
The unit is supplied with a country - correct AC
adapter. All DC conversion, regulation and filtering
is done within the 7602 MKII. The output of the AC
adapter is 24VAC and connects to the rear of the unit.
Optionally, you may use the CPS-1 Power Supply to
power this unit. The unit will auto select which
power supply is connected so there is no user
required action.
The CPS-1 uses a 4 pin, screw on type connector to
provide power to run the Model 7602 MKII unit. A
Model CPS-1 power supply is optional to power this
unit. The CPS-1 power supply contains a toroidal
transformer to reduce 60Hz hum. To insure quiet
operation, mount the power supply at least one rack
space away from the Model 7602 MKII main unit,
and locate the AC adapter as far away as is practical.
The Model 7602 MKII does not come with an
interconnecting DC cable that will connect it to one
of the two power outputs on the CPS-1. If you order a
CPS-1 for this unit, please be sure to ask for the DC
cable to be included. A CPS-1 will power two Model
7602 MKII units. Be careful when connecting the
power cable to insure correct mating of the two
connectors. They are keyed and should go in with
very little effort and then screw down for added
safety. If more than gentle pressure is required, it is
8