Vehicle security, Anti-theft alarm system, Vehicle security -13 – CHEVROLET 2012 Equinox User Manual

Page 47: Vehicle personalization, Vehicle security -13 anti-theft alarm system -13

Advertising
background image

Black plate (13,1)

Chevrolet Equinox Owner Manual - 2012

Keys, Doors, and Windows

2-13

3. Press and hold the button on the

liftgate adjacent to the latch until
the turn signals flash and a beep
sounds to indicate that the new
setting is recorded.

When power opened with the
3/4 mode selected, the liftgate stops
at the new set position.

If you do not hear the audible and
visual feedback when setting the
intermediate stop position, you are
attempting to set the height below
the 3/4 open height minimum
(approximately 1.5 m or 5 ft). The
liftgate cannot be set below that
minimum and the new setting will
not be recorded.

Manual Operation of Power
Liftgate

To change the liftgate to manual
operation, turn the mode switch to
the OFF position.

With the power liftgate disabled and
all of the doors unlocked, the liftgate
can be manually opened and
closed. Manual operation of a

liftgate that also has power
operation requires more effort than
a standard manual liftgate.

To open the liftgate, press the
touchpad on the handle on the
outside of the liftgate, and lift the
gate open. To close the liftgate, use
the pull cup to lower the liftgate and
close. With the power liftgate
disabled, the liftgate electric latch
will still power latch once contact is
made with the striker. Always close
the liftgate before driving.

If the RKE button is pressed while
power operation is disabled, the turn
signals flash and the liftgate will
not move.

The liftgate has an electric latch.
If the battery is disconnected or has
low voltage, the liftgate will not
open. The liftgate will resume
operation when the battery is
reconnected and charged.

Vehicle Security

This vehicle has theft-deterrent
features; however, they do not make
it impossible to steal.

Anti-theft Alarm System

This vehicle has an anti-theft alarm
system.

Arming the System

To arm the system, do one of the
following:

.

Press

Q

on the RKE transmitter.

.

Lock the vehicle using the key in
the driver door.

The alarm automatically arms after
about 30 seconds. The security
light, located on the instrument
panel, flashes.

Press

V

on the RKE transmitter to

open the liftgate without setting off
the alarm. The system rearms when
the liftgate is closed.

Advertising