Rear axle, Starter switch check, Rear axle -32 starter switch check -32 – CHEVROLET 2012 Colorado User Manual

Page 282: Electrical

Advertising
background image

Black plate (32,1)

Chevrolet Colorado Owner Manual - 2012

10-32

Vehicle Care

Rear Axle

When to Check and Change
Lubricant

It is not necessary to regularly
check rear axle fluid unless there is
a leak suspected or an unusual
noise is heard. A fluid loss could
indicate a problem. Have it
inspected and repaired.

How to Check Lubricant

To get an accurate reading, the
vehicle should be on a level
surface.

The proper level is from 0 mm to
10 mm (0 to 3/8 in) below the bottom
of the fill plug hole, located on the
rear axle.

What to Use

See Recommended Fluids and
Lubricants on page 11‑12
to
determine which kind of lubricant
to use.

Starter Switch Check

{

WARNING

When you are doing this
inspection, the vehicle could
move suddenly. If the vehicle
moves, you or others could be
injured.

1. Before starting this check, be

sure there is enough room
around the vehicle.

2. Firmly apply both the parking

brake and the regular brake.
See Parking Brake on
page 9‑45
.

Do not use the accelerator
pedal, and be ready to turn off
the engine immediately if it
starts.

3. For automatic transmission

vehicles, try to start the engine
in each gear. The vehicle should
start only in P (Park) or
N (Neutral). If the vehicle starts
in any other position, contact
your dealer for service.

For manual transmission
vehicles, put the shift lever in
Neutral, push the clutch pedal
down halfway, and try to start
the engine. The vehicle should
start only when the clutch pedal
is pushed down all the way to
the floor. If the vehicle starts
when the clutch pedal is not
pushed all the way down,
contact your dealer for service.

Advertising