CHEVROLET 2011 Express - Manual (Page 184)

Black plate (10,1) Chevrolet Express Owner Manual - 2011
7-10 Infotainment System
Satellite Radio
Finding a Category (CAT)
Station
CAT (Category): The CAT button is
used to find XM™ stations while the
radio is in the XM™ mode.
XM™ is a satellite radio service that
is based in the United States and
Canada only.
Finding a Station
BAND: Press to switch between
FM1, FM2, AM, and XM.
The selection displays.
f (Tune): Turn clockwise or
counterclockwise to increase or
decrease the station frequency.
© SEEK ¨ : Press the arrows to go
to the previous or to the next station
and stay there.
To scan stations, press and hold
either arrow for two seconds until a
beep sounds. The radio goes to a
station, plays for a few seconds,
then goes to the next station.
For AM-FM Radio and Radio with
CD (Base), the station frequency
flashes while the radio is in the scan
mode. Press either arrow again to
stop scanning.
The radio seeks and scans stations
only with a strong signal that are in
the selected band.
For AM-FM Radio and Radio with
CD (Base), scan presets within the
current selected band by pressing
and holding either SEEK arrow for
four seconds until a double beep
sounds. The radio goes to a stored
preset, plays for a few seconds if a
strong signal is present, then goes
to the next stored preset. The
station frequency flashes while the
radio is in the scan mode.
Setting Preset Stations
If the radio does not have a
FAV button, up to 18 stations
(six FM1, six FM2, and six AM),
can be programmed on the
six numbered softkeys, by
performing the following steps:
1. Turn the radio on.
2. Press BAND to select FM1,
FM2, or AM.
3. Tune in the desired station.
4. Press and hold one of the
six numbered softkeys for
three seconds until a beep
sounds. When that softkey is
pressed and released, the
station that was set, returns.
5. Repeat the Steps 2 through 4 for
each softkey.