Vehicle care 10-89 – CHEVROLET 2011 Express User Manual

Page 359

Advertising
background image

Black plate (89,1)

Chevrolet Express Owner Manual - 2011

Vehicle Care

10-89

{

WARNING

Batteries can hurt you. They can
be dangerous because:

.

They contain acid that can
burn you.

.

They contain gas that can
explode or ignite.

.

They contain enough
electricity to burn you.

If you do not follow these steps
exactly, some or all of these
things can hurt you.

Notice: Ignoring these steps
could result in costly damage to
the vehicle that would not be
covered by the warranty.

Trying to start the vehicle by
pushing or pulling it will not
work, and it could damage
the vehicle.

1. Check the other vehicle. It must

have a 12-volt battery with a
negative ground system.

Notice: Only use a vehicle that
has a 12-volt system with a
negative ground for jump
starting. If the other vehicle does
not have a 12-volt system with a
negative ground, both vehicles
can be damaged.

2. Get the vehicles close enough

so the jumper cables can reach,
but be sure the vehicles are
not touching each other. If they
are, it could cause a ground
connection you do not want. You
would not be able to start your
vehicle, and the bad grounding
could damage the electrical
systems.

To avoid the possibility of the
vehicles rolling, set the parking
brake firmly on both vehicles
involved in the jump start
procedure. Put an automatic
transmission in P (Park) or a
manual transmission in
N (Neutral) before setting the
parking brake.

Notice: If the radio or other
accessories are left on during the
jump starting procedure, they
could be damaged. The repairs
would not be covered by the
warranty. Always turn off the
radio and other accessories when
jump starting the vehicle.

3. Turn off the ignition on both

vehicles. Unplug unnecessary
accessories plugged into the
cigarette lighter or the accessory
power outlet. Turn off the radio
and all lamps that are not
needed. This will avoid sparks
and help save both batteries.
And it could save the radio!

4. Open the hoods and locate the

positive (+) and negative (−)
terminal locations of the other
vehicle.

On your van, use the unpainted
radio antenna bracket as a
remote negative (−) terminal.

Advertising