CHEVROLET 2011 Express - Manual (Page 195)

Black plate (21,1) Chevrolet Express Owner Manual - 2011
Infotainment System 7-21
To connect an iPod, connect one
end of the USB cable that came
with the iPod to the iPod’s dock
connector and connect the other
end to the USB port located in the
center console or on the instrument
panel. If the vehicle is on and the
USB connection works, “OK to
disconnect” and a GM logo may
appear on the iPod, and iPod
appears on the radio display.
The iPod music appears on the
radio’s display and begins playing.
The iPod charges while it is
connected to the vehicle if the
vehicle is in the ACC/ACCESSORY
or ON/RUN position. When the
vehicle is turned off, the iPod
automatically powers off and will
not charge or draw power from the
vehicle's battery.
If you have an older iPod model
that is not supported, it can still
be used by connecting it to the
auxiliary input jack using a standard
3.5 mm (1/8 in) stereo cable. See
“Using the Auxiliary Input Jack”
earlier for more information.
Using the Radio to Control a
USB Storage Device or iPod
The radio can control a USB
storage device or an iPod using the
radio buttons and knobs, and
display song information on the
radio’s display.
f (Tune): Turn to select files.
© SEEK: Press to go to the start of
the track, if more than 10 seconds
have played. Press and hold or
press multiple times to continue
moving backward through tracks.
¨
SEEK: Press to go to the next
track. Press and hold or press
multiple times to continue moving
forward through tracks.
s
REV (Reverse): Press and
hold to reverse playback quickly.
Sound is heard at a reduced
volume. Release
s
REV to
resume playing. The elapsed time
of the file displays.
\ FWD (Fast Forward):
Press and hold to advance playback
quickly. Sound is heard at a reduced
volume. Release
\
FWD to
resume playing. The elapsed time
of the file displays.
4
(Information): Press to display
additional information about the
selected track.
Using Softkeys to Control a
USB Storage Device or iPod
The five softkeys below the radio
display are used to control the
functions listed below.
To use the softkeys:
1. Press the first or fifth softkey
below the radio display to
display the functions listed
below, or press the softkey
below the function if it is
currently displayed.
2. Press the softkey below the
tab with the function on it to
use that function.