Whirlpool DISHWASHERS - Manual (Page 7)

U S I N G Y O U R D I S H W A S H E R
Turn the Cycle Control knob clockwise to
point to the desired cycle. Heavy Wash
and Pots & Pans cycles share the same
spot on the dial. The Cycle Selector
button determines which cycle operates.
You will feel a definite stop at each cycle
mark. The dishwasher will automatically
start the cycle you selected.
NOTE: If the door is latched, you will hear
cycles start and stop as the knob passes
each cycle mark. This is normal and will
not hurt the dishwasher. If you prefer, you
can set cycles with the door unlatched.
LIGHT WASH
NORMAL WASH A
HEAVY WASH
POTS & PANS
RINSE & HOLD
DELAY
Starting your dishwasher using delay wash
You can set the dishwasher to start a cycle from 1 to 4 hours later.
1. Push desired Cycle Selector button.
2. Push desired Option Selector butlon(s).
3. Turn Cycle Control knob clockwise to the
number of hours (from 1 to 4 hours) you
want the dishwasher to delay before the
selected cycle starts.
4. Close and latch the door. The DELAY/
WATER HEATING signal light will come
on until the selected cycle starts.
NOTE:
• You can add items while time is counting
down. Close and latch the door. The Cycle
Control knob will not advance if the door is
unlatched.
• Rinse & Hold and Light Wash cycles
cannot be delayed.
• The DELAY/WATER HEATING signal light
will also come on while the water is heating
during all cycles.
LIGHT WASH
NORMAL WASH
HEAVY WASH m ( I ll
POTS & PANS Ml I I §
yyj
2
DELAY 3^»^^--------
HOURS 4
The clean signal light
The CLEAN signal light will come on when a
washing cycle is complete. To turn it off, turn
the Cycle Control knob clockwise slightly
until the light goes off.
DELAY
WATER
HEATING