Whirlpool DISHWASHERS - Manual (Page 8)

U S I N G Y O U R D I S H W A S H E R
Adding a dish during a cycle
You can add an additional item to the dishwasher anytime before the Cycle Control knob
reaches LIGHT WASH. See page 10.
1. Lift up on the door latch to unlatch the 3. Close the door. Do not latch it. Wait 30
door and stop the cycle. Wait a nroment seconds for air in the dishwasher to warm
for the spray action to stop before open- up. This helps reduce the amount of
ing the door. moisture that can come from the vent
2. Open the door and add the dish. when restarting the cycle.
4. Press door in to latch it. The dishwasher
will start where it stopped.
Changing a cycle setting
You can change a setting anytime during any cycle
1. Lift up on the door latch to unlatch the
door and stop the cycle.
2. Turn the Cycle Control knob clockwise to
the cycle you want.
3. Push the desired Cycle Selection button.
4. Check the detergent dispenser to be sure
it is properly filled for the new cycle. See
page 11.
NOTE: Turning the Cycle Control knob
may cause the covered section of the
detergent dispenser to open. Be sure to
fill the covered section if the cycle uses
detergent in both sections.
Close and latch the door. The dishwasher
will automatically start the new cycle.
Changing an option
You can change an option anytime during a
cycle. To change the selected option(s):
1. Push the RESET OPTIONS button.
2. Push an Option Selector button for each
desired option.
RESET
OPTIONS
□
Canceling a cycle
You can cancel a cycle anytime during the cycle.
1. Turn the Cycle Control knob slowly
clockwise to the drain portion of the wash
or rinse. You will hear water draining
when you have advanced to the proper
location.
2. Let the dishwasher drain completely.
3. Lift up on the door latch to unlatch the
door.
4. Turn the Cycle Control knob clockwise to
point to OFF.