Cabletron Systems EMM-E6 - Manual (Page 88)

Security
7-2 What is LANVIEWsecure?
from the command line (stand-alone mode):
1. From the appropriate directory, type
spmarun r4sec <IP address> <SU community name>
The Repeater Security window, Figure 7-1 , will appear.
Figure 7-1. The Repeater Security Window
The Repeater Security window provides a list of the repeater interfaces available
on the EMM-E6, as well as command buttons that allow you to configure security
at the repeater, module, and port levels.
What is LANVIEW
SECURE
?
LANVIEW SECURE comprises a set of enhanced security features that have been
implemented on the new generation of Cabletron’s repeater MIM family (as
designated by the letter “S” at the end of the module name); these features are
supported beginning with EMM-E6 firmware version 2.00.16, with the newest
enhancements supported by firmware versions 3.11.xx and later.
NOTES
The spmarun script invoked first in the above command temporarily sets the environment
variables SPMA needs to operate; be sure to use this command any time you launch an
application from the command line. This script is automatically invoked when you launch
an application from the icon menu or from within the Hub View.
You must use a community name with Superuser access to run the Security application.
If there is a hostname mapped to your EMM-E6’s IP address, you can use <hostname>
in place of <IP address> to launch this application. Please note, however, that the
hostname is not the same as the device name which can be assigned via Local
Management and/or SPMA; you cannot use the device name in place of the IP address.