Camco 32 dB - Manual (Page 22)

3
4
5
1
2
4 OPERA
TION
USER MANUAL
VORTEX 6, 4, 2.6 and 200V P.21
VORTEX Filter Assembly
1 Clip Apertures
2 Injection Moulded Cradle
3 Foam Filter
4 Injection Moulded Surround
5 Injection Moulded CAMCO Badge
4.7 Filter Cleaning
The air intake on the front of your VORTEX is fi tted with a removable fi lter
system. If the fi lter becomes clogged, the unit will not cool as effi ciently as it
should and may result in reduced output levels.
For changing the fi lter, no tools are required: fi rst, gently slide the whole plastic
fi lter assembly a few millimetres to the left and lift it from the front panel. Next,
beginning on one of the long sides, carefully unclip the moulded surround (4)
from the cradle (2) and then carefully pull the CAMCO badge (5) out of the four
fastening holes with both hands. Remove the foam fi lter (3) and clean it with a
mild dishwashing detergent and warm water. Once dry, replace the foam fi lter
carefully into the cradle and repeat the dismantling procedure in reverse. Insert
the fi ve pins on the fi lter frame into the clip apertures (1) and slide the fi lter
carefully to the right to secure.