Country Flame INGLS 24-N - Manual (Page 21)

Version 1.0b 21
OPERATING INSTRUCTIONS
FOR YOUR SAFETY READ BEFORE LIGHTING
WARNING: If you do not follow these instructions exactly, a fire or explosion
may result causing property damage, personal injury, or loss of life.
A. The Inglenook has a pilot light system that must be lit by hand.
Follow these instructions exactly, when lighting the pilot.
• If you cannot reach your gas supplier, call
the fire department.
B. BEFORE LIGHTING the pilot light, it is important to smell all around
the Inglenook for potential gas leaks. Be sure to smell next to the floor
because some gas fuel is heavier than air and will settle to the lowest
point. C. Use hand pressure to push in or turn the
ON/PILOT/OFF control knob. Do not use a
tool. If the control knob will not push in or
turn by hand, do not attempt repair. Call a
qualified service technician. Attempted repair
may result in fire or explosion.
WHAT TO DO IF YOU SMELL GAS
• Do not try to light any appliance.
• Do not touch any electrical switch; do not use any phone in your
building.
• Immediately call your gas supplier from a neighbor’s phone.
Follow the gas supplier’s instructions.
D. Do not use the Inglenook if any part has been
under water. Immediately call a qualified
service technician to inspect the Inglenook
and replace any part of the control system and
any gas control that has been under water.
LIGHTING INSTRUCTIONS
1. STOP! Read the safety information above this section. 8. Push in and turn the ON/PILOT/OFF control
knob counterclockwise to “ON.”
2.
3.
4.
5.
6.
7.
Turn off all electrical power to the Inglenook.
Open the Inglenook bottom grill to expose the gas control panel.
Push in on the ON/PILOT/OFF control knob slightly and turn
clockwise to “OFF.”
Wait five minutes to clear out any gas. Then smell for gas including
near the floor. If you smell gas, STOP! Follow “B” of the safety
information above.
Turn ON/PILOT/OFF control knob counterclockwise to “PILOT.”
Push in the ON/PILOT/OFF control knob and hold in. By repeatedly
pressing the piezoelectric igniter, a pilot flame should appear. If
flame goes out repeat steps 5 thru 10. If flame stays lit, go to Step 10. 9.
10.
11.
Close the Inglenook bottom grill.
Turn on electrical power to Inglenook.
The Pilot flame should be visible in the lower
center between the logs.
ON
OFF
PILOT
HI
LO
PILOT
ADJ
IN OUT
TO TURN OFF GAS TO INGLENOOK
1. When servicing Inglenook, turn off electrical power. 3. Push in ON/PILOT/OFF control knob and
turn clockwise to “OFF.” Do not force.
2. Open the Inglenook bottom grill to gain access to control panel. 4. Close Inglenook bottom grill.
FIRST FIRE
Reduce odor by ventilating the room the first few times the unit is operated. Burn the first two fires no more than 15-
20 minutes. Allow the Inglenook to completely cool between burns. Burn the third fire 30-40 minutes and allow
proper cooling time. Operate the appliance according to the instructions contained in this manual.