GE ZET1SMSS - Manual (Page 3)

Installation Instructions
0^ Pre-Installation Checklist
ALL INSTALLATION INFORMATION
ON THE FOLLOWING PAGES IS TO
BE USED FOR SINGLE AND DOUBLE OVEN
INSTALLATION!
^ To Remove the Door
(if necessary)
0^
Remove packaging materials.
Check behind hinges and under
false bottom. Remove labels on the outside
of the door, plastic on trims
and panel, all tape around the oven,
and any shipping screws securing
the oven to the base pad.
Rack Supports
with Hex Nuts
Graphite
Lubricant
Broiler Pan
and Grid
Literature
Pock
0^
Open oven door and remove
literature pack, broiler pan and grid, oven
racks, rack supports and a bag with 9 hex
nuts.
Read Installation Instructions carefully
before you begin.
Be sure to place all literature. Owner's
Manual, Installations, etc., in a safe place
forfuture reference.
0^
0^
Door removal is not a requirement for
installation ofthe product, but is an added
convenience. To remove the door:
Open the oven door as far as it will go.
Push both hinge
locks down toward
the doorframe,
to the unlocked
position. This may
require a flat-blade
screwdriver.
Hinge
Slot
Hinge Lock
(Unlocked
Position)
Hinge Arm
--------
DONOT LIFTTHEDOOR
BY THE HANDLE!
1= =M
0^
0^
Place hands on both sides
ofthe door, and close the
oven door to the removal
position, which is most of
the way closed.
Liftdoor up and out
until the hinge arms
clear the slots.
Removal Position
Hinge
Clears Slot
NOTE: The oven door is very heavy. Be sure you
have afirmgrip before lifting the oven door
offthe hinges. Use caution once the door is
removed. Do not lay the door on its handle. This
could cause dents or scratches.
Place the oven on a table or platform
even with the cutout opening. (Platform
must support 175 lbs. [79 kg] single, 350
lbs. [159 kg] double.)
Remove the bottom trim from the top of
the oven. Itwill be installed atthe end
ofthe installation process. The trim is
wrapped separately and taped to the
top ofthe unit.
0^
0^