GE ZET1SMSS - Manual (Page 4)

Installation Instructions
Al
CutoutforSingle Built-In Oven
CutoutWidth
28 1/2" Min.
28 5/8" Max.
•^(72.4to 72.7 cm)
7 3/4"
(19.7c^)
T^ax!
Allow 11/16"
(1.75 cm) for
overlap of_
oven over
side edges
ofcutout
Cabinet Width 30" (76.2 cm)
-Opening
Between
Inside
Walls Must
Be At Least
28 1/2"
(72.4 cm)
Wide
Cutout
Height
27 1/4" Min.
27 5/16" Max.
(69.2to 69.4 cm)
21
"
(53.3 cm)
Junction
Box Location
(junction box
maybeiocatedin Recommended
a^acentcabinet) CutOUtLOCation
from Floor
Cutout Depth
22" 55.9 cm)
CutOUtWidth
Min. to Bottom
ofJunction Box
CutoutHeight
Allow a minimum
of 21" (53.3 cm) for
clearance to adjacent
corners, drawers, walls,
etc. when
door is open
Allow 1" (2.5 cm)
minimum for
overlap ofoven
top and 1^/,"
(3.2 cm) overlap
ofoven bottom of
cutout
Cabinet
Width
30" (76.2 cmj^^n:;
Recommended cutout
location from floor 32
1/2" (82.6 cm)
If the cabinet does not have a solid bottom, two
braces or runners must be installed level with
the bottom of the cutout to support the weight
ofthe oven. For single ovens, the runners and
braces must support 200 lbs. (90 kg).
NOTE: Ifmarks, blemishes orthe cutout
opening are visible above the installed
oven, it may be necessary to add wood
shims under the runners and front trim
until the marks or opening are covered.
Side by Side Installations
Install two wall ovens in separate cutouts.
Allow
2"
(5.1 cm) min. between cutouts.
Suitable
Bracing
to Support
Runners
32 1/2" (82.6 cm)
23 l/2"(59.7cm)Min.
28 l/2"(72.4cm)Min.
28 5/8" (72.7 cm) Max.
27 1/4" (69.2 cm) Min.
27 5/16" (69.4cm)Max.
/i^
NOTE: Ifthe cabinet does
not have a front frame and the
sides are less than 3/4" (1.9 cm)
thick, shim both sides equally to
establish the cutout width.
Install a
solid bottom
or 2"X 4"
(5 cm X 10 cm) or
equivalent runners
level with bottom
ofcutout
Over Centerline
ofCabinet
Cutout - 2" (5.1cm) Cutout -
Observe all Min. Observe all
dimensions ◄---------------- ► dimensions
and and
requirements. requirements.
The solid bottom or runners must be level with
the bottom of the cutout, or the bottom trim
may not install correctly and then interfere
with the door opening.
This oven is not approved for stackable
installation.