Cabinetry, Cutoutfor frameless cabinets, Frameless cabinets – GE ZET1SMSS User Manual
Page 7
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Cabinetry
A4
Single Oven Cutout
for Installation Over
a Monogram Warming
Drawer
A5
Double Oven Cutout
for Installation Over
a Monogram Warming
Drawer
Per Warm
ing Drawer
Requirement
Anti-Tip Block Against
RearWall PerWarming
Drawer Requirement
2" (5.1 cm) Min.
NOTE:
Install the
oven only with spe
cific models listed on
the label located on
top ofthe oven
1" (2.5 cm) Min. Above Toekick or
Adjustto Oven Installation Height
NOTE: Additional clearances between cutouts may
be required. Check to be sure the oven supports
above the Worming Drawer location do not ob
struct the required interior depth and height.
Anti-Tip Block
Against Rear
Wall Per Worm
ing Drawer
Requirement
Per Worm
ing Drawer
Requirement
1" (2.5 cm) Min. Above Toekick
When installing a Monogram Worming Drawer
below a single or double oven, a separate 120V,
60 Hz, properly grounded receptacle must be
installed. Refer to
installation instructions pocked with the
Worming Drowerforspecific installation
requirements.
A6
Cutoutfor Frameless Cabinets
Frameless Cabinets
Whenever possible, order 30" (76.2 cm) frameless
cabinet with the cutout sided to fit
the oven. If using stock cabinets, additional fin
ished filler pieces may be required to
cover the opening.
• A stock frameless cabinet cutout width
may be up to 28 3/4" (73 cm). If necessary, odd
1/2" (1.3 cm) cleats to the sides, fiush with the
front edge ofthe side panels to accept mount
ing screws.
Cabinet Depth
23 1/2" (59.7 cm)
Min. From Inside
Bock to Front of
Cabinet Frame
or Side Panel
3/4" (1.9 cm) Min.
Thick Bottom Shelf
Cut Back Flush with
Front of
Side Panel