GE ZET1SMSS - Manual (Page 5)

Installation Instructions
A2 Cutoutfor Double Built-In Oven
Cutout
Width
28 1/2"
(72.4 cm) Min.
" 28 5/8" -
(72.7 cm) Max.
7 3/4"
(19.7 cm)
Max.
Allowll/16"
(1.8 cm) for
overlap ofoven
over side edges of
cutout
Allow a minimum
of21" (53.3 cm) for
clearance to adjacent
corners, drawers,
walls, etc. when
door is open
21
"
(53.3 cm) '
Opening
Between
Inside Walls
Must Be
At Least
28 1/2"
(72.4 cm) Wide
Allow 1" (2.5 cm)
minimum for
overlap of oven
top and IVn"
(3.2 cm) overlap o'
oven bottom
ofcutout
■30"
(76.2 cm).
Cabinet
Width
Cutout
Height
5113/16"
(131.6 cm
51 15/16"
cm) Max.
Min,
(131.8
Junction Box
Location
47" (119.4 cm)
Min. to Bottom of
Junction Box
Recommended cutout
location from floor
12" (30.5 cm)
If the cabinet does not have a solid bottom, two
braces or runners must be installed level with
the bottom of the cutout to support the weight
ofthe oven. For double ovens, the runners and
braces must support 375 lbs. (169 kg).
Cabinet Width 30" (76.2 cm)
Recommended
Cutout
Location
from Floor 12" (30.5 cm)
Cutout Depth 23 1/2" (59.7 cm) Min.
Cutout Width 28 1/2" (72.4 cm) Min.
28 5/8" (72.7 cm) Max.
Cutout Height 5113/16" (131.6cm)Min.
5115/16" (131.8 cm) Max.
NOTE: Ifthe cabinet does
not have a front frame and the
sides are less than 3/4" (1.9 cm)
thick, shim both sides equally
to establish the cutout width.
Suitable
Bracing
to Support
Runners
0
NOTE: Ifmarks, blemishes orthe cutout
opening are visible above the installed
oven, it may be necessary to add wood
shims under the runners and front trim
until the marks or opening
are covered.
%
Install a
solid bottom
or 2"X 4"
(5 cm X 10 cm) or
equivalent runner
level with bottom
ofcutout
215/8"
(54.9 cm)
Over Centerline
of Cabinet
The solid bottom or runners must be level with
the bottom ofthe cutout, or the bottom trim
may not install correctly and then interfere
with the door opening.