Cabinetry – GE ZET1SMSS User Manual

Page 8

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

Cabinetry

A7

Single Oven Cutout

for Installation Below

a Monogram Advantium
or Microwave Oven

A8

Single Oven Cutoutfor

Installation Between a
Monogram Advantium or
Microwave Oven anda
Monogram Warming Drawer

Per Advantium or
Microwave Oven
Requirement

2" (5.1 cm) Min.

Per Advantium or
Microwave Oven
Requirement

Note:

Install the oven

only with specific

models listed on the
label located on top of

the oven.

NOTE: The middle rail separating the two

openings may need to be larger than the

2"

(5.1 cm) minimum shown. Always refer to the

individual installation instructions pocked with

each product for specific requirements.

Combined Advantium or

Microwave Oven and Wall Oven
Installation:

When installed in combination with a

Monogram single wall oven, use separate electri-

coljunction boxes.

• Refer to the Advantium or microwave

oven installation instructions for electrical
requirements ofthat product.

• These connections must be made

by a qualified electrician. All electrical
connections must meet National Electrical
Code or prevailing local codes.

2" (5.1 cm) Min.

2" (5.1 cm) Min.

PerWarming Drawer
Requirement

NOTE: Additional clearances may be required.

Check to be sure the oven supports above the
Warming Drawer
do not obstruct the required interior depth and
height. The middle rail separating the openings
may need to be larger than the

2"

(5.1 cm) minimum shown. Always refer to the

individual installation instructions pocked with

each product for specific requirements.

Warming Drawer Combined with
Advantium or Microwave Oven
and Single Oven:

Install a separate 120V, 60Hz, properly ground­

ed receptacle. See installation

instructions pocked with each product

for specific requirements.

Advertising
This manual is related to the following products: