Kenmore 15828 - Manual (Page 10)

signal LlgíaSs
Water Heating
The Water Heating light glows to indicate the dish­
washer is heating water to the proper
dishwashing temperature If your
household water is not hot enough
NOTE: The eiectronic time display
will pause while this occurs.
® Ail cycles (except Quick Rinse)
automaticaliy heat water during the final rinse.
Water heating is automatic in the wash portions
of the Pots Pans cycie.
Water heating is an option in the main wash of the
Normal Wash and Water Miser cycles.
Sani Complete
The Sani Complete light glows at the end of the
cycle indicating a high temperature,
sanitary rinse was completed.
NOTE: A flashing Sani Complete light
indicates that a high temperature, sani­
tary rinse was not completed. The Sani
Gompiete light will flash at the end of
the cycle if the dishwasher door is opened, power
fails, or water heating is not completed during the
final rinse. You may need to turn your water heater
temperature up so water is at least 120°F (49°C) as
it enters the dishwasher.
mi
Use Delay Wash when you want a cycle to start
later. Delay Wash can be set to start
the dishwasher during times when
off-peak utility rates are in effect or
when you are away from home.
WASH
1. Close the door firmly until you hear it latch..
2. Press the Delay Wash pad and one hour of delay
will show on the display. Each time
you press the Delay Wash pad, the
delay time will Increase in one-hour
settings. The longest delay setting
is 9 hours.
Hours of delay
3. Press pads for desired cycle and options.
4, The display will show the number of hours remain­
ing until washing begins. The display will show
hours only: If the display shows 2, there is be­
tween 1 hour and 1 hour 59 minutes remaining,
6, When the hours of delay you have set have
elapsed, the dishwasher will start the cycle se­
lected in Step 3. The wash time will count down
the minutes remaining in the cycie to 0.
If you wish to put more dishes in the dishwasher
while it is in the delay mode, be sure to latch the door
after adding them The timer will not advance unless
the door is latched. To cancel Delay Wash, press the
Cancel/Drain pad.
iSli© Cii^
In addition to showing remaining delay or cycie
time, the digital display will show a code indicating
the dishvArasher’s condition:
PF will appear in the display the first time the
dishwasher is connected to the elec­
trical supply after instaiiation. This
display also indicates there was a
power failure. Press Cancel/Drain to
drain the dishwasher. If there is no water in the
dishwasher, press Cancei/Drain a second time,
Reselect a cycle to restart the dishwasher.
CC will appear on the display when the dishes are
washed and the cycle completed,
Opening the door or pressing the
Cancel/Drain pad will dear the display.
E2 will appear in the display if the selector pads are
stuck. Press Cancel/Drain to release
the controis, or run your fingers across
the pads to free them up. If E2 remains
in the display, cal! for service.
10