Kenmore ELECTRIC RANGE 790.4660 - Manual (Page 14)

The CLOCK pad is used to set the clock. The clock may be set for 12 or 24 hour
time of day operation. The clock has been preset at the factory for the 12 hour operation.
When the range is first plugged in, or when the power supply to the range has been
interrupted, the display will flash with "
PF" (power failure, See Figure 1).
When PF appears in the display, press No sound will be heard, but after 10 seconds
a beep will sounds and PF will disappear.
INSTRUCTIONS
To set the clock (example below for 1:30)
Setting Oven Controls
Setting the Clock
PRESS
1. Press (cioc^. "CLO" will appear in the display (Figure 2).
2. Press (5^ pads to set the time of day to 1:30
(Figure 3). "CLO" will stay in the display. Press "CLO"
will disappear and the clock will start (Figure 8).
Changing between 12 or 24 hour time of day display
Press and hold (a^. "CLO" will appear in the display (Figure
3). After 3 seconds, Q will appear in the display indicating that
the cooktop lockout is active (Figure 4). CONTINUE holding the
pad until "12Hr" (Figure 5) or "24Hr" (Figure 6) appears in the
display.
2. Press
4.
to switch between the 12 and 24 hour time of day
display. The display will show either "12Hr" (Figure 5) or "24Hr"
(Figures).
Press to accept the desired change or press to
reject the change (Figure 7).
Press and hold (cio^ until Q disappears to cancel the cooktop
lockout feature if desired (Figure 8).
Reset the correct time as described in
To set the Clock above.
Please note that if the 24 hour time of day mode was chosen,
the clock will now display time from 0:00 through 23:59 hours.
C D ® ®
for? seconds
or ; tof
'Cl^'
■a.oo P F
Figure 1
DISPLAY
Figure 2
jn ri h
□ U LL U
Figure 3
idu LUy
Figure 4
Figure 5
Figure 6
Figure 7
Figure 8
14