Kenmore ELECTRIC RANGE 790.4660 - Manual (Page 36)

DISPLAY
Figure 1
INSTRUCTIONS PRESS
Stopping or Interrupting a Self-Cleaning Cycle
If it becomes necessary to stop or interrupt a self-cleaning cycle due to
excessive smoke or fire in the oven:
1. Press I
2. Once the oven has cooled down for approximately 1 HOUR and the
"DOOR", "LOCKED" icon is no longer displayed, the oven door can
beopened(Figurel).
IMPORTANT NOTES when using the Self-Clean feature:
1. The Seif-Clean feature will not operate whenever a radiant element remains ON.
2. A Self-Clean cycle may be started if the appliance has the
Cooktop Lockout active. A Self-Clean cycle cannot be
started if Oven Lockout feature is active.
3. If a Self-Clean cycle has started but not finished and a power failure occurs, the appliance may not have thoroughly
cleaned. Once power is restored, set for another Self-Clean cycle to finish.
4. If your clock is set for normal 12 hour display mode the Delay Self-Clean cycle can never be set to start more than
12 hours in advance. To set for Delay Self-Clean 12-24 hours in advance see instructions to set the control for the
24
hour time of day display mode.
Self-Cleaning (confd)
Adjusting Oven Temperature
The temperature in the oven has been preset at the factory. When first using the oven, be
sure to follow recipe times and temperatures. If you think the oven is cooking too hot or too
cool for the temperature you select, you can adjust the actual oven temperature to be more
or less than what is displayed. Before adjusting, test a recipe by using a temperature setting
that is higheror lower than the recommended temperature. The baking results should help
you to decide how much of an adjustment is needed.
INSTRUCTIONS
To adjust the oven temperature higher
1. Press (^ ba Ì^ for 6 seconds (Figure 2).
2. To increase the temperature use the number pads to enter the
desired change. (Example 30°F) CD® (Figure 3). The
temperature may be increased as much as 35°F (19°C).
3. Press to accept the temperature change and the display will
return to the time of day (Figure 4). Press to reject the change
if necessary.
To adjust the oven temperature lower
1. Press for 6 seconds. 0° will appear in the display (Figure 2).
2. To decrease the temperature use the number pads to enter the
desired change. (Example -30°F) ®® and then press
(Figure 5). The temperature may be decreased as much as
35°F(19°C).
3. Press to accept the temperature change and the display will
return to the time of day (Figure 4). Press to reject the change
if necessary.
36
PRESS
S tart ) or
Note: The oven
temperature adjustments
made with this feature
will not change the Self­
Clean cycle temperature.
DISPLAY
@ ®
liiliiiliil
¡1
Figure 2
D P
Figure 3
lOn
I j u
^B a ^
Figure 4
ISsii:Мy|мМММ;М:'|C an'
®®
mmmmrnmm:
au
Figures