Soft w/vter service and regeneration, Water flow through the softener in backwash, How your water softener works – Kenmore INTELLISOFT 625.38376 User Manual
Page 27
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
How Your Water Softener Works
SOFT W/VTER SERVICE AND REGENERATION
BRINING:
During brining, the brine is moved from the
salt storage area, into the resin tank. Inside the resin
tank, brine cleans hardness minerals from the resin
beads and they are discharged out the drain. How
much brine is needed to clean the resin depends on:
• The amount of water used between regenerations.
• The amount of resin in the softener,
• How fast the brine goes through the bed.
The nozzle and venturi makes suction to take brine
from the salt tank and put it into the resin tank. They
keep the brine flow down to a very slow rate to get the
best resin cleaning with the least salt.
BRINE RINSE:
After all of the brine is moved into the
resin tank, the brine valve closes. Water keeps flowing
the same way it did during brining except the brine flow
has stopped. Hardness minerals and brine flush from
the resin tank to the drain. Brining and brine rinse
together vary in the length of time they take, relative to
the fill cycle length.
BACKWASH:
During backwash, water flows UP
through the resin tank at a fast rate to flush iron miner
als, dirt and sediments from the bed and to the drain.
The bed lifts and expands for good cleaning.
WATER FLOW THROUGH
THE SOFTENER IN
BRINING AND BRINE RINSE
Hard Water Hard Water
Bypass OUT IN
FIG. 51
WATER FLOW THROUGH THE
SOFTENER IN BACKWASH
Hard Water Hard Water
Bypass OUT IN
♦ f
Questions? Call The Kenmore Water Line 1-800-426-9345
27