Kenmore 596.50012100 - Manual (Page 15)

м m
mm
l«W ЯШ
^CAUTION
To avoid personal injury or property
damage, observe the iollowing:
3> Confirm shelf is secure before
placing items on shelf.
> Handle tempered glass shelves
carefully. Shelves may break
suddenly it nicked, scratched, or
exposed to sudden temperature
change>
SPILLPROOF SHELVES
Splllproof Shelves hold
simple spills for easier
cleaning
> To remove shelves, lift
up and out
> To install shelves, reverse above
procedure.
Spillproof Slide-out
Shelves feature the
convenience of
easy cleaning
with a pullout
design to reach
items in the back. For ease of cleaning,
glass shelf may be removed by pulling
to full extension and lifting out of frame
DOOR SIORAfil
BEVERAGE
COMPARTMENT
(SOME MODELS)
The temperature-controlled beverage
compartment keeps beverages and
other items colder than the rest of the
fresh food section. Air inlet allows air
from the freezer section to pass to the
beverage compartment
Controls
The control is located on the left wall of
the fresh food section. Control adjusts
amount of air circulating in the beverage
compartment. Turn control clockwise for
colder temperature
To remove and install the beverage
compartment:
> if located directly above the beverage
compartment, dairy center or door
bucket may need to be removed.
Refer to appropriate Instructions and
remove item.
Slide the
beverage
compartment
assembly up
and pull
straight out,
> To install, align one of the cold air
intake holes (A) with one of the two
air Wets (B) in door liner Push
assembly down onto door liner
retainer until it stops,
IMPORTANT: The beverage
compartment will not operate properly if
air intake holes are not aligned with air
inlet in door liner.
DAIRY CENTER
The Dairy Center provides convenient
storage for items such as butter, yogurt,
cheese, etc
This compartment is an adjustable
feature located in the door It can be
moved to several different locations to
accommodate storage needs.
To remove and install bln:
To remove,
slide dairy
center up and
pull out.
> To install, slide
assembly in
above desired door liner retainer and
push down until it stops
To remove and install dairy door;
> To remove, press in sides of dairy
door and pull out
> To install, slide sides of dairy door
inside dairy center until hinge points
snap into place.,
TILT-OUT DOOR BUCKETS
(SOME MODELS)
The TilLOut Bucket assembly consists
of a bucket and frame, providing
adjustable, convenient storage for food
items in door. The bucket assembly tilts
forward for easy access of items, and
lifts out for ease in cleaning and
adjusting.
To remove and install bucket:
>■ To remove
bucket, tip bucket
forward and pull
straight out to
remove
> To install bucket, slide bucket into
bucket frame and push bucket
upright.
To adjust bucket frame:
Remove bucket per
above instructions,
> Lift frame off door
support and place in
desired door location
DOOR BUCKETS
Door Buckets adjust to meet individual
storage needs.
> To remove, slide bucket
up and pull straight out,
>■ To install,
reverse above
procedure
Z
О
15