Kenmore 596.50012100 - Manual (Page 19)

flVt-BÜTTOMCONTROlfEÁUJiS
r ~i r~~i
WATírt CítteSií .........
I—II II—.
I dispenser
OPERATION
To dispense:
> Setect CUBE, CRUSH or WATER
mode by pushing button on dispenser
control panel. A green indicator light
above button shows mode selection
>* Press container against dispenser
pad Sefectfon mode may not be
changed while ice dispenser is in
operation.
NOTE: if water dispenser is
continuously active for more than 5
minutes, an automatic lock out sensor
wiil shut down power to dispenser area
For instructions on how to unlock your
dispenser, see the section entitied
Dispenser lock beiow
DISPENSER LOCK g|
This feature prevents ice or
water from being dispensed
To lock and unlock dispenser:
> To lock dispenser, press artd hold
LOCK/UNIOCK button for 3
seconds, A green indicator light
above button confirms dispenser is
locked.
> To unlock dispenser, hold
LOCKAJNLOCK button for 3
seconds Green Indicator light above
button will go out
FILTER STATUS
INDICATOR LIGHT
The filter status indicator light
serves as a reminder to
replace the water filter, A green light
indicates that the filter is in good
condition A red light indicates the filter
should be changed Once light turns red,
it will remain red until function is reset.
RLTEfl
To reset indicator:
> Press and hold both LOCKAJNLOCK
and WATER buttons simuitaneously
for 4 seconds. The green filter status
indicator light wilt flash 3 times when
the function has successfuliy reset
I AUTO LIGHT
The auto light function
offers the ability to activate the
dispenser light at haif-power when the
LIGHT SENSOR detects that the tight
levels in room are low
To activate and deactivate auto light:
>- To activate, press ON/OFF button
located on control panel, A green
indicator light above button displays
to show that sensor is active.
>• To deactivate, press ON/OFF button
Green Indicator light witi go out
NOTE: Dispenser light wiil operate
whether or not auto light is selected
SABBATH
MODE
j-y
This mode is intended to deactivate
power to the LED and dispenser tights,
whiie aliowing the controls to remain
operational-
To activate and deactivate Sabbath
Mode:
> To activate, press and hold both
LOCKAJNLOCK and ON/OFF
buttoris simultaneously for 3 to 4
seconds. After 3 to 4 seconds, the
LED and dispenser lights wiil turn off.
Oispenser light will not activate
during dispensing while in this
mode.
>• To deactivate, press and hold both
LOCKAJNLOCK and ON/OFF
buttons simultaneously lor 3 to 4
seconds. After 3 to 4 seconds, the
LED and dispenser lights wilt
activate
NOTE: in the event that power is
interrupted while the Sabbath Mode is
active, the control will remain in Sabbath
Mode when power returns
O
X
19