Installing your rftr, Stllctihg the best – Kenmore 596.50012100 User Manual

Page 6

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

INSTALLING YOUR RfTR

Thsse instructions were provided to aid
you in the instaltation of your

refrigeralot-

StllCTIHG THE BEST

When installing your refrigerator, please

reference chart below for clearance

requirements-

Subflooring or fioor coverings fi e.
carpet, tile, wood floors, rugs) may make
your opening smaller than anticipated.

Some clearance rnay be gained by
using the leveling procedure under

How to Level Your Refrigerator
(page 11),

Unit Tot^l

Volume

Recommended

Clearance

Top

Sides

Rear

Less than

23 cu ft

N/A

N/A

'//

Greater than

23 cu ft

14"

N/A

'/i"

IMPORTANT: if refrigerator is to be
instaiied into a recess where top of
refrigerator ts completely covered, use

dimensions from floor to top of hinge
cap to verify proper clearance

Follow these tips when moving the
refrigerator to final location;

>■ NEVER transprt refrigerator on its

side If an upright position is not
possible, lay refrigerator on its back,
Allow refrigerator to sit upright for
approximately 30 minutes prior to
plugging refrigerator in to assure oil
returns to the compressor. Plugging
refrigerator in immediately may cause

damage to internal parts.

> Use an appliance dolly when moving

refrigerator, ALWAYS truck
refrigerator from its side or back-
NEVER from its front.

> Protect outside finish of refrigerator

during transport by wrapping cabinet

in blankets or inserting padding
betweert the refrigerator and dolly

Secure religerator to doily firmly with
straps or bungee cords, TTiread sfiaps

through handles when possible, DO NOT

overtighten. Overfightenlng resfralnts may
derst or damage outside finish

Observe these points when choosing the
final location for your refrigerator:

>- DO NOT install refrigerator near

oven, radiator or other heat source If

not possible, shield refrigerator with

cabinet material

> DO NOT install where temperature

falis below 55“ F (13“ C) Malfunction
may occur at this temperature

> To assure proper door closure, follow

the leveling instructions in the

section, How to Level Your

Refrigerator (page 11).

Advertising
This manual is related to the following products: