Kenmore 596.50012100 - Manual (Page 9)

flow TO INSTALL AND
MMOVE PANES
Jk WARNING
To avoid possible injury and damage
to property, tape decorative panels
{some models) securely into place
when door handles are removed.
A CAUTION
To avoid personal injury or
property damagef observe the
foSlowing;
> Refrigerator panels should not
weigh more than 30 pounds |14
kiiograms) and freezer panels
should not weigh more than 15
pounds (7 kilograms),
> Protect soft vinyl or other flooring
with cardboard, rugs or other
protective material.
> Protect hands and arms by
wearing gloves,.
NOTE:
5» To protect door surfaces from being
scratched, cover back edges of
decorator panels by placing masking
tape along back edges
Save all screws and reuse in origina!
locations.
(6 mm) Panel Dimensions
Extended
Door
Panel
Panai
Height
Panel
Width
Fresh food
door
66 74"
(169 5 cmj
ta ’7«’’
(46,1 cm)
Upper
dispensing
freezer door
18'/."
(46 cm)
13 '7.7
(35 ,4 cm)
Lower
dispensing
freezer door
32
(81 5 cm)
13 '7,."
(35 4 cm)
Non­
dispensing
freezer door
66 77
(169 5 cm)
13 ’7."
(35 4 cm)
INSTALLING PANELS
1Remove top trim screws with a
Phillips screwdriver and remove top
trim.
Slide handle upward until
loose. Remove handle
from door
Remove door
retainer dips with
a '/7' hex head
driver.
ih
4. Slide bottom of panels into bottom
door trim until hinge side of decorator
pane! rests under hinge side trim.
IMPORTANT: Tape tops of panels to
door to prevent panels from failing
5. Reinstall door
retainer clips with
a H" hex head
driver,
6 Reinstall handle by inserting retaining
dips on door into notches on back of
handle.
> Slide handle down until it contacts
bottom trim.
7. Remove tape from
tops of panels
before reinstalling
top door trim with
Phillips screws
removed in step 1
REMOVING PANELS
1 Remove top trim screws with a
Phillips screwdriver and remove top
trim
IMPORTANT: Tape tops of panels to
door to prevent panels from falling, m
O
Slide handle upward until
loose. Remove handle
from door
Remove door
retainer ciips with
a K" hex head
driver.
1^
4. Remove tape to slide panels out of
door trim
5 Refer to steps 5, 6 and 7 of
Instating Panels to install handles
and trim,
9