Inset 2 17 – Kenmore 119.1643301 User Manual
Page 17
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Install Heat Diffusers, Cooking Grates, Warming Rack
□
Insert the heat diffusers into the firebox by placing them into the indentations in the front and
back of the firebox. See Inset 1.
n Place the Cooking Grates into the firebox. The grate bottoms have a small knob on each corner.
See Inset 2.
□
Insert the warming rack into the top of the firebox. See Inset 3. The raised lip goes towards the
back of the firebox. See Inset 3.
Inset 3
Inset 1
O
.•.......... *.
..............................
Inset 2
Place and Secure LP Cylinder into the Cabinet
□
Unscrew the bolt and nut located below the large opening in the left side cabinet panel. Attach
the regulator hose support ring, located on the regulator hose, to the left side cabinet panel
using the same bolt and nut. See Inset 1
□
Hook the ends of the Cylinder Support Ring into the two holes in the left front and rear legs.
See Inset 2. Note: You may need to spread the ends apart for the ring to reach and securely fit
into the holes.
□
Place the LP cylinder down into the tank support hole in the bottom of the cabinet. Ensure the
valve faces to the side. Wrap the Cylinder Support Ring around the top of the tank and hook
together to secure the LP cylinder in place. See Inset 3.
Do Not Hook Up the LP Cylinder to the Regulator Assembly at this time.
Inset 1
Inset 2
17