Converting the lower element (cont’d), Awarntng, A warning – Kenmore Power Miser 12 153.320493 HT User Manual
Page 12: A caution, Installation instructions (cont’d)
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Converting the Lower
Element (cont’d)
9.
Tighten terminals 2 and 3 to ensure proper electrical
connection.
Installation Instructions (cont’d)
12. The adjustment dial has a “D” shaped opening that matches
a “D” shaped shaft on the thermostat. Align the opening in
the dial to the shaft and gently push the dial onto the shaft.
AWARNtNG
Failure to tighten terminal screws can cause a fire which
can result in DEATH, SERIOUS BODILY INJURY, OR
PROPERTY DAMAGE.
10. Replace terminal cover on the thermostat, making sure the
notch is in place over the cab.
Q
nm
tfr
FQSI
Bntc
PLLL MVni
AT TCP Cf
OTJSt
13. Replace the access panel.
A WARNING
Make sure the thermostat is flush against the tank, the
terminal cover is in place, and the insulation is replaced.
Failure to do so can result in DEATH, SERIOUS BODILY
INJURY, OR PROPERTY DAMAGE.
11. Replace the insulation block so that it completely covers the
thermostat and element.
14. Complete wiring to the water heater, or if completed, turn
“ON” electric power to the water heater after filling the
tank with water.
A CAUTION
Never use this water heater unless it is completely full of
water. To prevent damage to the tank and heating ele
ment, the tank must be filled with water. Water must
flow from the hot water faucet before turning “ON”
power.
12