Removing the old water heater, A warning, A caution – Kenmore Power Miser 12 153.320493 HT User Manual

Page 6: Installation instructions

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

Removing the Old Water
Heater

^^Turn “OFF” electrical supply to the water heater.

Installation Instructions

lElllli

Turn

“OFF

water

heater

water meter.

” the water supply to t

at the water shutoff valve

the

or

©

Attach a hose to the water heater drain
valve and put the other end in a floor

drain or outdoors. Open the water heater
drain

valve.

Open

a

nearby

hot

water

faucet which will relieve pressure in the

water heater and speed draining.

r5ja. If you have copper piping to the wsi^^CT

heater, the two copper water pipes can be
cut with a hacksaw approximately 4" away

from

where

they

connect

to

the

water

heater. This will avoid cutting off the pipes

too

short.

Additional

cuts

can

be

made

later if necessary. Disconnect the tempera­
ture-pressure

relief

valve

drain

line,

’'^en

the water heater is drained, disconnect the
hose from the drain valve. Close the drain

valve. The water heater is now completely

disconnected and ready to be removed.

b. If you have galvanized pipe to the water

heater,

loosen

the

two

galvanized

pipej

with a pipe wrench at the union in eadri
line. Also disconnect the piping remaining
to the water heater. These pieces should be
saved

since

they

may

be

needed

when

reconnecting

the

new

water

heater.

Disconnect

the

temperature-pressure

relief

valve drain line. When the water heater is
drained,

disconnect

the

hose

from

the

drain

valve.

Close

the

drain

valve.

The

water heater is now completely disconnect­
ed and ready to be removed.

A WARNING

The water passing out of the drain valve may be extreme­

ly hot. To avoid being scalded, make sure all connections

are tight and that the water flow is directed away from
any person.

^4 J Check again to make sure the electrical supply is

turned “OFF” to the water heater. Then disconnect
the

electrical

supply

connection

from

the

water

heater junction box.

A CAUTION

Mineral buildup or sediment may have accumulated in the
old water heater. This causes the water heater to be
much heavier than normal and this residue, if spilled out,
could cuise staining.

Advertising