Flush out the tubing, Connect the tubing to the refrigerator, Turn the water on at the shutoff valve – Kenmore ELITE 795.7104 User Manual
Page 30: Plug in the refrigerator, Start the icemaker
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
CONNECTING THE WATER LINE
8. FLUSH OUT THE TUBING
Turn the main water supply on
and flush out the tubing until the
water is clear.
Shut the water off at the water
valve after about one quart of
water has been flushed through
the tubing.
9. CONNECT THE TUBING TO THE
REFRIGERATOR
NOTE:
Before making the connection to the
refrigerator, be sure the refrigerator power
cord is not plugged into the wall outlet.
1. Remove the plastic flexible cap from the water
valve.
2. Place the compression nut and ferrule (sleeve)
onto the end of the tubing as shown.
3. Insert the end of the copper tubing into the
connection as far as possible. While holding the
tubing, tighten the fitting.
A
CAUTION;
Check to see if leaks occur at water
line connections.
10. TURN THE WATER ON AT THE
SHUTOFF VALVE
Tighten any connections that leak.
11. PLUG IN THE REFRIGERATOR
Arrange the coil of tubing so that it does not
vibrate against the back of the refrigerator or
against the wall. Push the refrigerator back to
the wall.
12. START THE ICEMAKER
Set the icemaker power switch to the
On (I)
position.
NOTE:
A newly installed refrigerator may take
several hours to start producing ice.
A
CAUTION;
Check to see if water dripping
occurs at water line connections.
30