Kenmore 625.38811 - Manual (Page 22)

J J j :^. м . м J J j :^. м . м J J j :^. м . м J J j :^. м . м !
SECTION 5 SERVICE TECH. INFORMATION
A. TROUBLESHOOTING
CORRECT
SWITCH
DISPLAYS VALVE CYCLE STATUS
—
Valve in service, fill, brining,
backwash or fast rinse position
„ p
Valve rotating from one position
to another
While in this diagnostic screen^ the following in­
formation is available and may be beneficial for
various reasons. This information is retained by
the computer from the first time electrical power
is applied to the face plate.
-- Press 0 to display the number of days this
face plate has had electrical power applied.
- - Press 0 to display the number of regenera­
tions initiated by this face plate since the SR code
number was entered.
Press and hold the SELECT button until...
SR17 shows.
CODE
5R I
This code identifies the softener nominal capacity
size. If the wrong number shows, the softener will
operate on incorrect programming. Do the follow­
ing as needed.
Return the present time display
LECT button. Press the SE-
To change SR number — Press the UP or DOWN
button until the correct SR code shows. Then, press
the SELECT button and reset the timer...page 1-3.
TIMER PWA REPLACEMENT; Be sure the
valve is in service position when replacing the
timer PWA (observe valve cycle indicator).
If, after installing and programming the re­
placement timer PWA, the valve is not in ser­
vice position, do the following to assure correct
cycle orientation, or timing, between the face­
plate and valve.
Use the MANUAL ADVANCE procedures,
page 5-4. With the RECHARGE button, ad­
vance through the recharge cycles until the
valve stops in service position, and RE­
CHARGE no longer flashes in the display.
NOTE; The valve motor may automatically
drive through several valve positions while
searching for service. If an error code occurs,
unplug the transformer, then plug in again.
5 - 3
Problems, Questions? Call 1-800-426-9345 Kenmore Water Line