Kenmore 625.38811 - Manual (Page 5)

j: J J: J J: J J: J J:
■ JJ JJ-È.J JJ JJ-È.J JJ JJ-È.J JJ JJ_È
J: SECTION 1 lj:.i J: J: J: J:
МJJ_И.jJJJJ_È.jJJJJ_È.jJJJJ_È.jJJ.
WATER SOFTENER START UP
B. CHECK LIST OF STEP-BY-STEP GUIDES TO INSTALL
To be sure you have done all the steps to install the
softener, read the following list. Refer to the Instal­
lation Manual, part no. 7267336, for step-by-step
guides.
Page numbers referred to are in the Installation
Manual unless otherwise noted.
Is the house water flow going i]sjxo the softener
valve INLET? Trace piping to be sure. See pages
2- 4 and 2-5.
Is the plumbing bypass valve (or 3 valves) set for
SERVICE? Bypass valve(s) should always re­
main in soft water service position. Position in
"bypass" only if needed for softener repairs. See
FIG. 14, page 4-1 of this manual.
Is the valve drain hose connected the right way,
and without sharp bends or kinks that could
stop or reduce water flow? See page 3-5 in the
installation manual.
Page numbers referred to are in the Installation
Manual unless otherwise noted.
Is the transformer plugged into an inside, al­
ways live, grounded, 120V-60Hz electrical out­
let? See pages 3-8 and 3-9 in the installation
manual, and the wiring schematic on page 5-1 of
this manual.
Be sure to restart the water heater. See page
3- 9.
Bypass Valve (s)
NOTE; Codes in the state of Massachusetts require installation
by a licensed plumber. For installation, use plumbing code
248- CMR of the Commonwealth of Massachusetts.
1-2
Problems, Questions? Call 1-800-426-9345 Kenmore Water Line