C. water flow through the softener valve, Brining and brine rinse cycles, Backwash cycle – Kenmore 625.38811 User Manual
Page 26: Service tech. information
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Ls j j:^.i.i j j j:^.i.i j j j:^.i.i j j j:^.i.i!
SECTION 5
SERVICE TECH. INFORMATION
C. WATER FLOW THROUGH THE SOFTENER VALVE
BRINING AND BRINE RINSE CYCLES
After fill, timer/switch action allows the motor to turn the rotor and disc into BRINING position.
Water flow is directed to the nozzle. Suction, created by the nozzle and venturi, draws brine from the
salt storage tank and injects it into the resin bed via the bottom distributor. Flow continues out the top
distributor and to the drain. Hard water is available at the valve outlet.
When the brine valve doses to end brine draw, water flow continues in the same directions to slowly
RINSE brine from the resin bed and to the drain.
BACKWASH CYCLE
Timer/switch action again allows the motor to turn the
rotor & disc to place the valve in BACKWASH, stopping
water flow to the nozzle. Water is routed down and out
the bottom distributor, up through the bed, and out the
top distributor to the drain. The fast flow (controlled by a
flow plug in the drain fitting) flushes dirt, sediments,
iron deposits, remaining brine and hardness to the drain.
5 - 7
Problems, Questions? Call 1-800-426-9345 Kenmore Water Line