Kenmore 362.72239 - Manual (Page 10)

SETTING THE CONTROLS
lock and Timer
(on some modeis)
r-------------
TIM era
OH/OfFf
f iri nn
CLOCK
V-------------
1 l O Q Q
SET TiStE
lappearance may vary)
Follow the directions below if your range has the clock
and timer shown above. You have the choice of having
the timer show the time counting down or the time of day.
In either case, the timer will signal at the end of the timer
period to aiert you that the time is up.
To Set the Clock
NOTE: When you first plug in the range or after a power
failure, the entire Clock/Timer display will light up.
1. Press the CLOCK pad.
2. Press and hold the A or ▼ pad and the time of day
will change 10 minutes at a time. To change the time
by single minutes, give the pads short taps.
3. Press the CLOCK pad to start the clock.
To Set the Timer
1. Press the TIMER ON/OFF pad.
2. Use the A or ▼ pads to set the timer. Short taps
on the A or T pad change the timer’s setting one
minute at a time. Pressing and continuing to hold the
A pad increases the setting ten minutes at a time.
3. Once you have set your timer, press the TIMER
ON/OFF pad to start timing As the timer counts down
a signal will indicate when one minute is left. After this
signal, the display will count down in seconds When
time runs out, a final signal will sound. Press the
TIMER ON/OFF pad to stop the signal.
To Change or Cancel the Timer Setting
When the timer is counting down, use the A or T pads
to change the remaining time, or press the TIMER
ON/OFF pad to stop the timer. The timer cannot be
cancelled unless you have fully completed "set timer"
instructions above.
To Display the Clock While
the Timer is Operating
Pressing the CLOCK pad white the timer is operating will
not interfere with the timer's operation; the display will
change to show the clock, but the timer will continue to
count down and will still signal when time is up. Press the
TIMER ON/OFF pad again to change the display back to
show the timer,
10